Restoring Windows system to earlier state is the easiest way to solve the problem that happens on your Windows computer. But, there are cases when the system image restore failed on Windows. Is there anything we can do when we’re experiencing it? Yes, there are several solutions for this case.
This system image restore failed can happen to Windows 10/8/7. There are two cases that can lead you to have this error on your Windows PC. You can read on the solutions based on the cases down below.
Solutions to Fix Fix System Image Restore Failed on Windows
Case 1: The System Image Restore Failed 0x80070057
Use CHKDSK Command
The System Image Restore failed 0x80070057 happens on Windows PC due to corrupted hard disk. Therefore, running a check disk on Windows PC is a good solution to do. This method is quite simple. Follow the following steps-wise to do so:
- Open the Search box of Windows and type cmd. Right-click on Command Prompt and select Run as administrator. If the computer cannot boot, try to go to WinRE and choose Command Prompt.
- Type chkdsk c: /f and hit Enter key. The progress will start immediately to locate the error in the hard drive and fix it.
- Restart PC.
Now, check whether the system image restore failed 0x80070057 has resolved. If the error persists, try to reinstall Windows Operating System.
Case 2: The System Restore Failed Windows Cannot Restore a System Image
Solution 1: Make Sure the Destination Disk Has the Same Partition Style as the Source System Disk
You should understand that the target disk that you want to restore the image should have similar type of disk. For instance, if the partition type of disk where you create the system image is an MBR, then the target disk should be an MBR too. If the type is different, you should convert it to MBR.
How to convert the partition disk so that they have the same type? There is a powerful tool to help you convert the partition disk: MiniTool Partition Wizard Professional Edition. Its Bootable Media feature allows you to boot the PC and enter WinPE to do the conversion on Windows 10/8/7.
Solution 2: Ensure the Destination and Source Computer Are Using the Same Boot Mode
Not only the partition type should be similar, but also the boot mode on your computer. If the backup was created on a UEFI computer, then the targeted computer should enable UEFI mode. While if it was created in a BIOS computer, you should change the boot mode to the Legacy.
How to change the firmware mode? Press a specific key (each computer has different key) while restarting to boot your PC to the boot menu. Select UEFI or Legacy.
Those were the solutions for System Image Restore Failed on Windows that could happen on two cases. Hopefully the methods can help you get rid of the error on your Windows PC. If you happen to experience the error in other cases, we suggest you to contact the technical support.
If you have any questions or suggestions, we are welcome for feedback. Thank you for reading, Folks!